Phase II tuner button replacements?

[John44]

Hello, first post and first PRS. Got a 2008 PRS DGT Goldtop and the tuner button for the high is not grabbing the little metal center piece that goes around the actual shaft that turns the strings. So the button just spins.
Does anyone one know of a replacement button that will fit my Phase 2 tuners? Id like a genuine PRS tuner button, but am just unsure on what will work for this exact model. I noticed that some Phase ii tuners are metal, while some are pearloid, and they look like different screw configurations. Any help appreciated and Ill add a couple photos.

 

[John44]

Well can’t figure out pictures yet, but my tuners have pearloid buttons and each tuner has 2 screws on the back of the headstock . Anyone know why my tuner screw won’t seem to go back on with the button?​

 

[Rider1260]

Well it seems the Phase II buttons have fallen off the face of the earth I did find these on reverb
Usually John Mann Guitar Vault has loads of parts

https://reverb.com/item/2048892-ton...ner-buttons-6-fits-prs-phase-i-ii-schaller-m6

 

[John44]

Thanks, I saw a few like that but wasn’t sure they would fit. Looks like my best bet for now. I tried calling PRS customer service, But it must of been a general number that could only help with warranty issues.

 

[John44]

Follow up.. I got Ninja tone pro buttons 6 for about $40. First one I tried was defective. The metal piece in the middle immediately was stripped. Second is working so far, but I had to drill the screw hole a bit so the screw could actually pass through and hold on the button. If it fails I’ll let you know.