Hi everyone!
Hope to find some help over here.
I searched literally everywhere and was not able to fine the thing.
I'm going to install Seymour Duncan Distortion Trembucker with Cover (this is important!) in the bridge of my PRS and really dislike the fact that the original pickup string spacing is narrower than that of the Floyd Rose. Strings and pickup poles does not align perfectly like I prefer on all my other guitars. I know it is purely aesthetics, but whatever
So the question is where to find the right pickup ring?
Original ring that comes with the PRS is not working - trembucker cover is wider than ring inner width.
Dimarzio pickup rings are no go too (they are the same dimensions as PRS).
SD ring that comes with the pickup has wider ring mount screws placement, so would not fit at all.
The only option I see is to sand the Dimarzio ring...but I was looking for an elegant factory solution...
Cannot sand the PRS ring because their pickup mounting screws are too close to the edge and there is no room to do it.
Some numbers:
Original PRS ring inner width is around 71mm.
SD trembucker with cover is about 74mm wide.
Does anyone know where to get right pickup ring?
many thanks,
Alexi
Hope to find some help over here.
I searched literally everywhere and was not able to fine the thing.
I'm going to install Seymour Duncan Distortion Trembucker with Cover (this is important!) in the bridge of my PRS and really dislike the fact that the original pickup string spacing is narrower than that of the Floyd Rose. Strings and pickup poles does not align perfectly like I prefer on all my other guitars. I know it is purely aesthetics, but whatever
So the question is where to find the right pickup ring?
Original ring that comes with the PRS is not working - trembucker cover is wider than ring inner width.
Dimarzio pickup rings are no go too (they are the same dimensions as PRS).
SD ring that comes with the pickup has wider ring mount screws placement, so would not fit at all.
The only option I see is to sand the Dimarzio ring...but I was looking for an elegant factory solution...
Cannot sand the PRS ring because their pickup mounting screws are too close to the edge and there is no room to do it.
Some numbers:
Original PRS ring inner width is around 71mm.
SD trembucker with cover is about 74mm wide.
Does anyone know where to get right pickup ring?
many thanks,
Alexi