Hello,
I recently acquired a gorgeous Wood Library Artist Package Custom 24 and I am having some issues setting it up. I've had a CE24 and a 2001 Custom 24 10 top in the past, and I have realized that the tremolo on both of those was set below the factory 1/16 " bridge height, as I received both of those used. The new guitar's bridge appears to be the right height, but I am having problems setting it at the correct angle. I know it's supposed to be parallel to the body, but given the carve of the top this is throwing me off a little. As far as the 1/16th measurement goes - is this measured from the front or the back of the tremolo? Can anyone with a correctly setup CU24 post a picture of the bridge angle from the side? I would be extremely grateful.
I recently acquired a gorgeous Wood Library Artist Package Custom 24 and I am having some issues setting it up. I've had a CE24 and a 2001 Custom 24 10 top in the past, and I have realized that the tremolo on both of those was set below the factory 1/16 " bridge height, as I received both of those used. The new guitar's bridge appears to be the right height, but I am having problems setting it at the correct angle. I know it's supposed to be parallel to the body, but given the carve of the top this is throwing me off a little. As far as the 1/16th measurement goes - is this measured from the front or the back of the tremolo? Can anyone with a correctly setup CU24 post a picture of the bridge angle from the side? I would be extremely grateful.