The switch was not the requirement, it was the electrical component soldered to the switch that was needed. So you can solder that component to a push pull instead of a switch and bingo, you are in. A number of years ago I got a wild hair and converted an SE Cu24 to the original 80's Cu24. I put in original HFS/Vintage pups, a rotary, and the sweet switch. It was a fun project. I tell you this to say that you can research what that component was. I have it somewhere but that was 2 computers ago and I'm not sure where it is now. I could probably find the sweet switch quicker. It's in a drawer somewhere.