Help wiring new Seymour Duncan’s in PRS SE Standard

[Dan V]

Hi folks,
Hoping somebody can help me with this - I know it’s been asked a million times with different guitars.

I just installed Seymour Duncan humbuckers in a PRS SE standard. Obviously, the leads are different.

I have a coil tap tone knob, and a 3-way switch. But now have more wires to deal with on the new humbuckers.

can somebody help me at least get sound running through both pickups?

thanks

 

[Boogie]

Hi folks,
Hoping somebody can help me with this - I know it’s been asked a million times with different guitars.

I just installed Seymour Duncan humbuckers in a PRS SE standard. Obviously, the leads are different.

I have a coil tap tone knob, and a 3-way switch. But now have more wires to deal with on the new humbuckers.

can somebody help me at least get sound running through both pickups?

thanks

3-way toggle or blade? Twin volume and tone pots? This is pretty accurate.

 

[Dan V]

Thanks Boogie. I’ve got one tone pot with coil tap. And one 3-way switch.

seymour Duncan says black is hot lead. Should that connect to switch position?

Red & white to coil tap connector?

green and bare wire to ground?

 

[Boogie]

There’s a slight change with only 1 vol/tone pot set. See above. Black leads go to switch, switch to volume pot, red/white are the coil split.

 

[Dan V]

There’s a slight change with only 1 vol/tone pot set. See above. Black leads go to switch, switch to volume pot, red/white are the coil split.

thanks for your help Man! That did the trick. Got the new Invaders working like a charm. Appreciate it!
Dan

 

[Boogie]

thanks for your help Man! That did the trick. Got the new Invaders working like a charm. Appreciate it!
Dan

Rock on, bud! Glad it helped. Now post up some pix of your project.