Paul Parise
New Member
- Joined
- Oct 24, 2018
- Messages
- 14
I just purchased a freeway ultra 6 way and emailed freeway to see if they could do a custom schematic.
Wondering if anyone here might have done this or could offer thoughts. Here’s the desired scheme, I’m using 85/15 pups:
PRS guitar, 2 humbuckers, one volume,One tone push pull. I’d like the first three positions to be your typical humbucker sounds (bridge hum, bridge&neck, neck), use the push pull to get the same but single coil (bridge single, bridge&neck single, neck single) and then positions 4,56 on the toggle to be bridge hum/neck single, inner coils parallel, neck hum/bridge single.
This would essentially give you McCarty Switching, current CU 24 5 way blade sounds, parallel inner coils for your Strat quack in between sounds.
Anyone try this or have any similar wiring schematics?
Wondering if anyone here might have done this or could offer thoughts. Here’s the desired scheme, I’m using 85/15 pups:
PRS guitar, 2 humbuckers, one volume,One tone push pull. I’d like the first three positions to be your typical humbucker sounds (bridge hum, bridge&neck, neck), use the push pull to get the same but single coil (bridge single, bridge&neck single, neck single) and then positions 4,56 on the toggle to be bridge hum/neck single, inner coils parallel, neck hum/bridge single.
This would essentially give you McCarty Switching, current CU 24 5 way blade sounds, parallel inner coils for your Strat quack in between sounds.
Anyone try this or have any similar wiring schematics?