Simon Says
Cathode Follower
About 6 months ago or so I have took the Phase 1 tuners out of my 99' Standard and replaced them with Phase III's.
Since I did that in rush, on cheap with my own hands I did it badly. They are off centre, old holes poking in the eye, I'm really surpised they holding tuning alright.
For past month I was gearing up in tooling and know-how on how to correct this.
The aim of this tread is not to make definitive set of instructions how to do this but I'm hoping some of the info I have collected will be of use to some.
I'm still not sure the final approach I will take to plug the holes. I have a selection of wood dowels and some epoxy putty. I will see what takes the dye and screws better on a scrap wood.
I'm currently making the plan for a jig which I will be using to drill new holes with a proper alignment. Jig will be laser cut and all plans will be shared here.
Wish me luck
Since I did that in rush, on cheap with my own hands I did it badly. They are off centre, old holes poking in the eye, I'm really surpised they holding tuning alright.
For past month I was gearing up in tooling and know-how on how to correct this.
The aim of this tread is not to make definitive set of instructions how to do this but I'm hoping some of the info I have collected will be of use to some.
I'm still not sure the final approach I will take to plug the holes. I have a selection of wood dowels and some epoxy putty. I will see what takes the dye and screws better on a scrap wood.
I'm currently making the plan for a jig which I will be using to drill new holes with a proper alignment. Jig will be laser cut and all plans will be shared here.
Wish me luck
Last edited: