justmund
Plank Spanker
and possibly completely unreliable
I've started compiling a bit of info on the various body and cap thicknesses of PRS Guitars. A fair bit of this is second hand info, with a lot of it coming from a VR thread which states that all maples caps on US models are 0.804", and standard (e.g. CU24) "body" thickness is 1.125".
Obviously there's a lot of models missing from this list, e.g. there's no SE info, so if anyone can get busy with a set of calipers and post up the info, I'll do my best to keep an updated list.
I'm assuming the thickest part of a carved top guitar would be at the bridge, so getting an accurate measurement might be difficult with standard calipers.
Also keen to get confirmation of any of the measurements. I do know the SC list isn't complete, looking for the original Singlecut thickness (apparently thicker than SCT but thinner than SC-58)
Anyway thought it might make for an interesting forum project
I've started compiling a bit of info on the various body and cap thicknesses of PRS Guitars. A fair bit of this is second hand info, with a lot of it coming from a VR thread which states that all maples caps on US models are 0.804", and standard (e.g. CU24) "body" thickness is 1.125".
Obviously there's a lot of models missing from this list, e.g. there's no SE info, so if anyone can get busy with a set of calipers and post up the info, I'll do my best to keep an updated list.
I'm assuming the thickest part of a carved top guitar would be at the bridge, so getting an accurate measurement might be difficult with standard calipers.
Also keen to get confirmation of any of the measurements. I do know the SC list isn't complete, looking for the original Singlecut thickness (apparently thicker than SCT but thinner than SC-58)
Anyway thought it might make for an interesting forum project