Recent content by bbosla

Hi, I am just updating the result. I just made mistake to recover it with Epi neck pickup cover which has 50mm pole piece spacing. Since they have a 0.8mm clearence, it's hard to tell the difference by eye. For this, I ve odered 49.2mm pup cover, and If i done the work, I will post it soon...

Thanks for your advice guys~! Anyway I am sorry for photo problem. I wold add my page address below and you'll see the picture by ctrl C + V. Btw, the pickup cover I tried, was Epi neck cover which has exact 49.2mm spacing. And the DRG was bit narrower than epi cover as garret said. And as...

Thanks Rider. I've tried this one. But this DRG is narrower than this cover.. ha... it takes me down..

Hmmm... the dc ohm is right. Just.. it doesn't make sense that treble has same pole piece spacing w neck. As sinskma said, their are chances some might have changed some neck pickup with original treble and switched the sticker. But there's no 12kohm neck pup on prs list. What do you think??

Hi guys. I got used Dragon ii Nickel Cover set recently. And the treble has no cover. I wanted to recover it with traditional size cover to look good. So... I tried 49.2 mm and... it doesn't match~!!! PRS is bit narrower than 49.2mm it's almost 48.8mm. It even doesn't fit with PRS SE bridge...

Thanks for your advice Eric. As you said, it might need some time to get it right, since it is not the math.

Hello guys~ I have an old se santana 2001 And there's some noise on tone pot. Also there's no nob as you see on my profile pic. I'd like to change it to push-pull pot, but I'm not sure which pot should I use, since there are two types of nob and pot; inch or mm. And if you have done push pull...

Hello~ I'm new in here, and I got Old Se Santana 2001 recently. Appearance is not pretty, but the sound killer~! But I got a big problem~ Help me out guys! For initial setting, the string height was 2mm at 12th fret at the beginning. After half turne of truss rod, it became 1.2mm. And there...