I was ready to do a setup on my 2019 PRS SE Paul’s Guitar after a string change. The low E was buzzing a bit so I got out the included truss rod wrench. WHAT? It does not fit in the routed TR cavity.
What’s up with that? I’m going to cut off a few mm so it may fit down into the TR Cavity. But this is something that is unacceptable.
I was under the impression that even the imports were gone over at PRS USA.
Anyone else run into this problem and if so what was your solution?
What’s up with that? I’m going to cut off a few mm so it may fit down into the TR Cavity. But this is something that is unacceptable.
I was under the impression that even the imports were gone over at PRS USA.
Anyone else run into this problem and if so what was your solution?