Roving_Drummer
New Member
- Joined
- Apr 7, 2021
- Messages
- 41
Ever since I changed my first battery on this thing, I knew one day a wire would snap. It finally did last week. It snapped from the battery compartment luckily. If it snapped from the board I'd be in trouble. I reattached it with a small piece of electrical tape and it's held up so far.
The battery just doesn't sit comfortably in the container PRS uses.
Am I playing with fire with my fix? Or should I get it repaired by a pro. I cannot solder at all. I tried when building electronic drums with piezo so my soldering myself is out of the question. Even if PRS resoldered it its going to snap again. It's just too flimsy. I'd be scared to use this live if I was a gigging guitarist.
The battery just doesn't sit comfortably in the container PRS uses.
Am I playing with fire with my fix? Or should I get it repaired by a pro. I cannot solder at all. I tried when building electronic drums with piezo so my soldering myself is out of the question. Even if PRS resoldered it its going to snap again. It's just too flimsy. I'd be scared to use this live if I was a gigging guitarist.