The action is high on my PRS SE CU24 even though the saddle is bottomed out. Also, the tremolo is sitting 2mm off the body (not the reccomeneded 1/16"). Is there a set of instructions i can follow to set the 6 screws up properly? Preferably with video or pics.
Also, another issue. The 6 tremolo screws are poking through into the trem cavity, where they have cracked and chipped the paint (only a mm or so) . Is that a common occurrence? Im a bit worried, as from what i can tell, i will need to lower those screws to get the trem height right? So they will be sticking out further?
FYI, im decent at setting up hardtails/flyods/fender trems. The nut is fine, i have a little relief and the tremolo is floating evenly (2mm off the body)
I found this vid that explains how to setup a replacement PRS trem but im not sure if those instructions are valid for the stock trem.
Also, another issue. The 6 tremolo screws are poking through into the trem cavity, where they have cracked and chipped the paint (only a mm or so) . Is that a common occurrence? Im a bit worried, as from what i can tell, i will need to lower those screws to get the trem height right? So they will be sticking out further?
FYI, im decent at setting up hardtails/flyods/fender trems. The nut is fine, i have a little relief and the tremolo is floating evenly (2mm off the body)
I found this vid that explains how to setup a replacement PRS trem but im not sure if those instructions are valid for the stock trem.