John Millette
New Member
- Joined
- Jul 13, 2020
- Messages
- 3
My PRS SE30 has been working famously since I purchased it in 2015. It is not the only amp I have but is my favorite with a 4-12 Ampeg cabinet. Recently the output went into the mud with barely a sound coming from the amp. I reseated all the tubes but no improvement at all. I figured I got my moneys worth from the original tubes so I replaced all 8 of them but guess what? Not the problem! I'm not the go-to guy when it comes to tube heads. I checked all fuses - 2 on the board, one screw in (typical fuseholder), and the one in the a/c cord connector - all checked out. I did read something about the reverb wiring but I was not fiddling with those wires. Like I said one day when I turned on the amp there was nothing except a faint sound. Any suggestions would be most welcomed. I have a fair amount of soldering experience and can replace components on a PCB board.
Thank you!
~J
Thank you!
~J