CoreyT
PRS Addiction
Here at work, just got done playing my 2012 SE Custom 24 before I start work.
Just noticed the input jack nut is loose, as I heard it clanking when inserting the cable.
I can tighten it up by hand, but do I risk spinning the inside jack and ripping off the wires, or will it be OK to insert a nut driver on it to tighten it up further?
Would it be better to take off the rear plate and hold the jack while tightening from outside, or will it be OK to tighten without removing the rear plate?
I have never had a nut loosen before on the jack of any guitar I have owned.
Thanks, Corey
Just noticed the input jack nut is loose, as I heard it clanking when inserting the cable.
I can tighten it up by hand, but do I risk spinning the inside jack and ripping off the wires, or will it be OK to insert a nut driver on it to tighten it up further?
Would it be better to take off the rear plate and hold the jack while tightening from outside, or will it be OK to tighten without removing the rear plate?
I have never had a nut loosen before on the jack of any guitar I have owned.
Thanks, Corey