Dr Excess
New Member
- Joined
- Dec 8, 2019
- Messages
- 23
I’ll try and whip up a diagram for you tomorrow morning, but what you’re asking is totally doable and in fact (slightly) easier than the normal MT wiring. No guarantees that it will produce a sound you want though. I imagine it will be quite a bit darker than what I consider a fairly brightly voiced 85/15. One small correction: you want DPDT ON/ON switches (not ON/ON/ON) so they only have two toggle positions.
Hey,
Thanks. I think actually in my second reply yesterday that will actually give me the on/on/on with the 3 voicing (out of choice)
Because those 3 stage switches go top two, then top left and bottom right, and then bottom two (obviously both middle always engaged), If I were to setup the micro toggles basically as standard (red/white on top and green black on bottom), that would mean toggle would go:
- Red / White (ignores extra winds on slug to make two relatively balanced coils - Normal 85/15 HB)
- Red / Green (all the winds - 10k unbalanced - New mode)
- Black / Green (ignores screw coil but includes all the winds on slug to beef up the output - 85/15 special louder Single as found on 24-08)
Red / White (ignores extra winds on slug to make two relatively balanced coils - Normal 85/15 HB)
Black / Green (ignores screw coil but includes all the winds on slug to beef up the output - 85/15 special louder Single as found on 24-08)
using the normal layout or in my customised layout as in the image (with red/green top and black/green bottom) I would then have:
- Red / Green (all the winds - 10k unbalanced - New mode)
- Black / Green (ignores screw coil but includes all the winds on slug to beef up the output - 85/15 special louder Single as found on 24-08)
I'm hoping this is correct otherwise I've totally misunderstood what you've been explaining.