SE Hollowbody II Piezo Mini Switch

[Ruxster]

Hoping I can get a bit of advice from here. I just purchased my first non-US made PRS guitar, a Hollowbody II Piezo. I am not loving the way the controls work for switching between piezo and magnetic pickups. Is it possible to have the mini switch control added to the SE model of the Hollowbody to match the US model?

 

[Lacire]

The LR Baggs piezo PC boards are totally different between the SE and Core. Specifically what is it about the controls you don’t like?

 

[aphantomvaper]

I just acquired one of these axes. I can see the ability to not change the piezo volume and change from mag to piezo with a switch would be nice. I've only had it for a couple days.

At a band rehearsal it was effort to roll down one and roll up the other. Even forgot the piezo was on and thought the Mags were shorted because they went tinny (I had rolled down the mags without realizing it)

Anyway, yeah OP a mini three way toggle would be nice. I'm sure it would drive up the cost some if they did that factory installed.

 

[NazgulUK]

Anyone mess with the electronics in a Hollowbody SE?

 

[NazgulUK]

And . . . .

https://forums.prsguitars.com/threads/se-hollowbody-piezo-electronics-wiring-thread.47423/

 

[Lacire]

And . . . .

https://forums.prsguitars.com/threads/se-hollowbody-piezo-electronics-wiring-thread.47423/

Looks like this thread posted by NazgulUK would have the information needed to install a three way switch in the SE HB II to give you the option of mag, mag plus piezo or piezo only.

 

[NazgulUK]

Yep, it's all been done and a lot of info there