SE CU 24 bridge screw question

Sillyak

New Member
Joined
Feb 10, 2018
Messages
13
I have a WMI made SE Custom 24. The 6 knife edge screws for the trem are not quite all level. 3 bass side ones are level E and G string ones are slightly down and the B string one is a bit more. It's not a big difference, probably a few thou, but I would think given the bridge design these should all be perfectly level no? It came from the factory this way (I watched the guitar store employee open the box when I bought it.) Should I make them all level?

r9fUApH.jpg
 
The one caveat I would note is that it's important for the indents of the screws to all be level, if the screws aren't all identical, then using the above technique isn't going to work.

If you really want to be safe, you'd need to remove the strings and springs, take all the screws out and ensure they are all *exactly* the same, and *then* use the above video as a guide.
 
Back
Top