sadmoodyfrazier
New Member
- Joined
- Aug 25, 2020
- Messages
- 102
Hi...
I have this problem over my PRS with the hi e saddle almost touches the baseplate of the bridge.
I made a regular setup following Marr's directives to set up the bridge height with 2.5 mm hex wrench and I made the action following PRS specs from official website.
I will post a picture later. I'm unable to right now.
By the fact that the bridge is an aftermarket one I suspect that the saddles are too thick.
May you tell me how much thick at the front end are the PRS USA and SE saddles for reference and to find which problem I have here?
Thank you in advance.
I have this problem over my PRS with the hi e saddle almost touches the baseplate of the bridge.
I made a regular setup following Marr's directives to set up the bridge height with 2.5 mm hex wrench and I made the action following PRS specs from official website.
I will post a picture later. I'm unable to right now.
By the fact that the bridge is an aftermarket one I suspect that the saddles are too thick.
May you tell me how much thick at the front end are the PRS USA and SE saddles for reference and to find which problem I have here?
Thank you in advance.