quick wiring question on 59/09 into NF3 blade switch

Discussion in 'PTC - PRS Tech Center' started by Luminandy, Aug 28, 2016.

  1. Luminandy

    Luminandy New Member

    Joined:
    Feb 21, 2015
    Messages:
    104
    Likes Received:
    37
    So I am really close here, and have searched will no luck. My 59/09 has a black and white (hot) and red (coil tap) wires. When I got it, the white was grounded to the blade housing. The black is on the proper place in the schematic. Pickup is weak sounding. I was wondering if I need to put both hot wires together on the proper tab which would make sense. Just would like to know for sure before pulling it all apart again. There is no hum or noise. Thanks in advance.
     
  2. Luminandy

    Luminandy New Member

    Joined:
    Feb 21, 2015
    Messages:
    104
    Likes Received:
    37
    Did more extensive research. I think that I just have the white (ground) on the blade, and it should be on the tone pot casing.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice