Push-pull pots for Bernie

[Mayfly]

I'm looking for push-pull pots for the SE Bernie. Going into the jungle of information I quickly realised I needed some guides on my quest. You guys (and gals) have always been a fountain of knowledge, so I'm turning to you once again....

I presume I need the metric measurements as this is not a US instrument?
I'm reading a lot about logarithmic and audio taper. What's the difference / best?
Long or short shaft?
... and finally, any recommended manufacturers?

Thanks! :top:

 

[ADP]

Here's an interesting fact: a DiMarzio 500K audio taper push-pull pot is very, very, very similar to the one PRS use. :wink: And would work in your Bernie.

 

[Mikegarveyblues]

Yep, I'd go with that. Audio taper is what's used most of the time. Pretty sure I used short shaft in my Bernie.

 

[Mayfly]

Here's an interesting fact: a DiMarzio 500K audio taper push-pull pot is very, very, very similar to the one PRS use. :wink: And would work in your Bernie.

I've had my eye on that one, thanks for the confirmation!