PRS SE Custom 24 - Push/Pull Tone Capacitor

Discussion in 'General Discussion' started by Andrew Middleton, May 28, 2020.

  1. Andrew Middleton

    Andrew Middleton New Member

    Joined:
    May 17, 2020
    Messages:
    2
    Likes Received:
    0
    Hi. Hope someone can help. I have a 2017 SE Custom 24. Unfortunately the push/pull tone potentiometer has broken and I need a new one. I've had a look and there is no info marked on it. Can anyone tell me what I need (ohm value, linear or logrithmic) and suggest somewhere I could order it from. I am happy with a direct replacement.

    Also the tone pot has a capacitor connected onto it. I noticed that it has some damage. It looks like the side has been touched with a soldering iron (presumably at the manufacturers). I'm not sure it this will affect anything but if I could find our what I need and where to obtain one I may as well replace this at the same time. The capacitor has 3333 MF 400V 3 written on the side.

    All help greatly appreciated.
     
    #1 Andrew Middleton, May 28, 2020
    Last edited: May 28, 2020

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice