Prs custom 24 wiring mod

[Gabrytherocker]

Hi folks, I recently purchased a core custom 24 wich I absolutely love. The only thing I’d like to change is position 4 of the switch wich I don’t use because it is too thin for me. I want it to be bass humbucker + treble single coil, so the exact opposite of position 2. What should I change in the wiring to make it happen? Thanks in advance!

 

[garrettb]

 

[Gabrytherocker]

Thanks man!!!

 

[garrettb]

Thanks man!!!

You're welcome.

I guess it might help to explain, on the switch there will be two red jumper wires on the lugs on the top right. The quickest thing to do is just move the jumper connection from the lug marked BD to the one marked A above. Leave the pickup wires where they are. The cleaner way to do it is remove the two jumper wires and solder a solid wire across the three lugs from A to the right, just like PRS did on the other poles. A clipped-off leg from a cap or resistor is ideal.

 

[Gabrytherocker]

Thanks a lot man, I’ll keep you updated

 

[Gabrytherocker]

It worked and it sounds great!! Thanks again