PRS 59/09 Humbucker only wiring.

[ESPImperium]

Im installing a 59/09 into my PRS Mushok SE with a Di Marzio Liquifire in the bridge.

Im wanting to use http://www.dimarzio.com/sites/default/files/diagrams/2h1v1t_3w_all.pdf as my wiring diagram, a simple Vol/Tone/3 way blade with no bells or whistles.

What are the wires i twist together out of the Black/Red/White ones in order to get the thing up and running properly?

Thanks.

 

[ESPImperium]

Trial and error, found the solution. Reading too much into what was not there.

 

[jwmcpeak]

Hi, ESPImperium.

I purchased a set of 59/09s and I'm looking into a no-frills setup (3-way blade, 1 vol, 1 tone, no split). Would you mind sharing your solution?

 

[ESPImperium]

I put my solution in the first post of the thread, but here it is again:

http://www.dimarzio.com/sites/default/files/diagrams/2h1v1t_3w_all.pdf

After trying that solution, im going to EMGs again in my SE Mushok as long as they work this time, but i have just had my FedEX delivery, so tomorrow i think im going to a 85/60 set up. As long as the thing dosnt short out this time, as last time there was EMGs in it it shorted out, but i may have a solution as i think the silverburst was shorting it out after i reamed the volume and tone control holes and removing the graphite paint in them. Ill try with and without my chosen solution to bring the fire back to my Mushok.