Piezo Bridge Question

[TSL]

Hello folks!

I have a question about replacing an adjustable piezo bridge on a 2010 Hollowbody II. I haven’t been able to find replacement for the bridge/piezo combo on-line. Can I reuse the old piezo module on a new bridge?

Thanks very much for the help!

 

[Malloc]

The bride has a push in connector under it so you can replace just the bridge module without the whole piezo system. You will, however, have to go through the PTC to do it.

 

[TSL]

The bride has a push in connector under it so you can replace just the bridge module without the whole piezo system. You will, however, have to go through the PTC to do it.

Thanks very much, Malloc
Just want to verify that they can reuse the current piezo so I can continue to use the Hollowbody like an amplified acoustic. I’ll check with PTC.
Best,
TSL

 

[Stringtheorist]

Hello. Did the OP have any success with replacing the bridge? The bridge on my P22 has lost a lot of its plating and looks very dishevelled, and I would like to replace it if this is viable.

 

[JasonE]

You will have to contact the PTC about that. They don't sell replacement parts for this any other way. The unit is made by L.R. Baggs but I doubt they will sell any parts for it since it is made under contract for PRS.