Need CU24 Wiring Help...

[Grapeshot]

Does anyone have a CU24/22 wiring diagram with a 3-way lever switch and push-pull? I have a newer CU24 that I had the PTC replace the 5-way with a 3-way and push-pull. I had 85/15s in there that I just pulled out to install 58/15s. You would think that the 3-way switch would act like a 3-way toggle, but it doesn't, and the way I 'think' it should be wired isn't working as the bass pickup coil split isn't working. The 58/15s have fewer wires, so maybe I am missing something... Thanks!

 

[garrettb]

Do your 58's just have a black wire with braided shield and a white wire?

If so, connect the braided wire to ground. You can do this by soldering one end of a piece of wire to the two pickup shields and the other end to a pot casing.

Black wires go to the blade switch. You can look at a Tele wiring diagram for inspiration.

White wires go to the push/pull where red wires of the 85's went.

And yes, a blade switch is a different beast than a toggle switch.