Installing a push pull pot in Custom 22 SE

Carfins

New Member
Joined
Jul 29, 2020
Messages
2
Hi, as in the title I'm looking to install a push/pull pot in my 2016 Custom 22 SE. I believe a few of this model were installed with PP pots but not all of them, and apparently I got the latter.

Inside the cavity there are 2 loose sets of white and green wires coming off the pickups, which I assume to be the extra pickup wires.

I've not done any guitar wiring before so was wondering if anybody has any diagrams that I could follow to install the new pot?

Thanks
 

shimmilou

Established in 1963
Joined
Mar 15, 2018
Messages
2,501
Is it a white and a green wire soldered together and connected to nothing else? Two sets of these white and green like this?

If so, this might be what you are looking for:

47854121602_35cb26d2ef_o.jpg
 
Last edited:

Carfins

New Member
Joined
Jul 29, 2020
Messages
2
Is it a white and a green wire soldered together and connected to nothing else? Two sets of these white and green like this?
Yes, there's 2 sets of white and green. I was wondering what to do with these and where these and the other wires currently soldered to the tone pot would go on the new pot
 
Top