Installing a Gen lll Trem

[dogrocketp]

I recently managed to get a Gen lll trem from a repair person. I've installed every other Generation of trem (Including all of John Mann's) on various PRSi without any problems. Does anyone have any experience putting the Gen lll on a PRS? I sent an email to Tech support, but haven't gotten an answer. Quite honestly, I don't find Ryan to be terribly forthcoming with answers to other questions over the years......

 

[sergiodeblanc]

I don’t think the holes match up?

The diameter of the screws are different, yeah?

 

[bodia]

I don’t think the holes match up?

The diameter of the screws are different, yeah?

I think this is correct

 

[gush]

I don’t think the holes match up?

The diameter of the screws are different, yeah?

I didn't realize hole placement was different?

 

[intothevoid]

If for any reason you decide to part with it, let me know

Been looking for one

 

[sergiodeblanc]

I didn't realize hole placement was different?

The surface area of the knife edges got bigger, so everything shifted a couple millimeters (from what I’ve been told).

It really only sank in and stuck with me because I found out you cannot slap a MannMade/MilCom on a September GOTM. @Bogner

 

[Bogner]

The surface area of the knife edges got bigger, so everything shifted a couple millimeters (from what I’ve been told).

It really only sank in and stuck with me because I found out you cannot slap a MannMade/MilCom on a September GOTM. @Bogner

Sad But True...