HFS "Moving the Hot"

Javamon

New Member
Joined
Jun 25, 2022
Messages
8
Hey guys, just installed HFS & Vintage Bass pickups in a Custom 24 SE with push/pull pot. I want to "Move the Hot" so that both slug side bobbins are active in single coil mode. Right now I've got both red wires going to the push/pull but it's sending both signals to ground. I think I want the bridge pickup to go to hot when the switch is up. Is this possible just using the single push/pull pot? Can anyone help with the wiring?
 
Doh! Figured it out. PRS had wired a jumper across the common terminals on the push/pull pot which was forcing everything to ground.
 
Last edited:
Back
Top