Forum Truss Rod Cover (and you thought I forgot about it, didn't you?)

I'll take 2 if I may

newbie here! :hello:

First post and I'm already spending money
 
Anyone have the new S2 Custom24 Made in Md? I'm thrilled that PRS is making an affordable US version but I was wondering what the experience has been?
 
Still kicking myself in the butt for not asking Paul if I could play one of the three guitars that were at the Meet & Greet a short time back.
I mean they were just a few feet in front of me :D
 
So when I read, "These will fit USA PRS", does this mean they will NOT fit an SE? if so, that makes me kinda sad because I probably wont own a USA PRS for several years unless my music career trips over a miracle
 
Slight gap on the bottom. :D
PRSDimensions.jpg

Pic from Google images
 
Just accept it - buy 2 FTRC's, then obviously, buy 2 USA PRS guitars to put them on! Why stress when you can GAS instead?

:vroam:
 
that just comes across as a bad decision. Compatability = better sales

We aren't tooled up to make SE TRC's in the Maryland factory. Stevensville is buzzing along with tons of projects and getting the US TRC made was quit an ordeal in and of itself. Unfortunately the SE specced covers ended up on the cutting room floor.

As mentioned earlier, this cover will fit your SE, but there will be a small gap near the nut.
 
Back
Top