vr6corrado
New Member
- Joined
- Jul 21, 2013
- Messages
- 65
I'll take 2 if I may
newbie here! :hello:
First post and I'm already spending money
newbie here! :hello:
First post and I'm already spending money
Forum Truss Rod Cover (and you thought I forgot about it, didn't you?)
- Thread starter Shawn@PRS
- Start date
TAJ
New Member
I would like two please. Thanks again Shawn for making this happen!! The end result looks amazing.
CoreyT
PRS Addiction
Still kicking myself in the butt for not asking Paul if I could play one of the three guitars that were at the Meet & Greet a short time back.
I mean they were just a few feet in front of me
I mean they were just a few feet in front of me
John Beef
Opaque
2 please!
Poffypoffa
New Member
- Joined
- Jul 8, 2012
- Messages
- 128
One for me please!
Johnnyboy94
New Member
So when I read, "These will fit USA PRS", does this mean they will NOT fit an SE? if so, that makes me kinda sad because I probably wont own a USA PRS for several years unless my music career trips over a miracle
DISTORT6
NJ Devil
Slight gap on the bottom.
Pic from Google images
Pic from Google images
Sage
Guitarchaeologist
- Joined
- May 23, 2012
- Messages
- 462
Slight gap on the bottom.
Pic from Google images
Does that include the SE Angelus?
MOBirds
New Member
Just accept it - buy 2 FTRC's, then obviously, buy 2 USA PRS guitars to put them on! Why stress when you can GAS instead?
:vroam:
:vroam:
Hopeful Sinner
Angry Southern Gentleman
Pretty sure the SE Angelus TRC is the same spec as a US TRC...
kmburkhart
New Member
I'll take one!
Shawn@PRS
yogi
I'm going to close this on Friday, so anyone who would like to order an Officiall Forum TRC, please do so by Friday. cheers
jfb
Plank Owner
If every request is paid for these sold extremely well. WOW!!!
Johnnyboy94
New Member
Slight gap on the bottom.
Pic from Google images
that just comes across as a bad decision. Compatability = better sales
Shawn@PRS
yogi
We aren't tooled up to make SE TRC's in the Maryland factory. Stevensville is buzzing along with tons of projects and getting the US TRC made was quit an ordeal in and of itself. Unfortunately the SE specced covers ended up on the cutting room floor.
As mentioned earlier, this cover will fit your SE, but there will be a small gap near the nut.
