CTS POTS & PRS KNOBS

[ViperDoc]

This has been discussed before, but I didn't find the answer I was looking for.

WHAT IS THE BEST WAY TO FIT A PRS LAMPSHADE KNOB ON A CTS POT *WITHOUT* SPLAYING THE SPLIT SHAFT WITH A SCREWDRIVER?

THANK YOU.

 

[Serious Poo]

why are you yelling?

 

[Boogie]

Are you using imperial dimension shafts?

 

[garrettb]

Uh, that's the way to do it my friend.

 

[bodia]

This has been discussed before, but I didn't find the answer I was looking for.

WHAT IS THE BEST WAY TO FIT A PRS LAMPSHADE KNOB ON A CTS POT *WITHOUT* SPLAYING THE SPLIT SHAFT WITH A SCREWDRIVER?

THANK YOU.

Well, if you don't want to splay the shaft, maybe some plumbers tape around it until you get it right.

 

[John Beef]

I splayed the shaft just this weekend. And that's not a euphemism for anything other than the subject we're talking about.

 

[ViperDoc]

why are you yelling?

BECAUSE I'M RIPPING A SOLO ON MY OTHER 594!!! IT'S A B!TCH TO TYPE AT THE SAME TIME, TOOOOO!!!!!!

 

[ViperDoc]

I splayed the shaft just this weekend. And that's not a euphemism for anything other than the subject we're talking about.

Also guilty of splaying the shaft. SPLAY ON.

 

[ViperDoc]

Well, if you don't want to splay the shaft, maybe some plumbers tape around it until you get it right.

I actually did this on my P24 I just fixed, but that tape will likely not be a long-term solution.

 

[ViperDoc]

Are you using imperial dimension shafts?

I don't think so, but then again I did get this pot from London. I didn't think it through...

 

[90sMcCarty]

Also guilty of splaying the shaft. SPLAY ON.

Splay on, Splaya...