Jeff Classen
New Member
- Joined
- Jun 26, 2021
- Messages
- 4
So.... It all started with a crackling Volume pot, but I am now wanting to change a few things on my S2 Singlecut Standard.
Currently the Tone Pots push pull to split the coils, and I would like to convert this to run them in parallel. I never use the split function and figure this might get me some more useful tones.
I can't seem to find a GOOD diagram to do this conversion.
Also considering changing tone Caps to a lower value as the .033 uf is just taking off too much of the treble.
Any Recommendations for Caps on the neck and bridge pickup?
Also considering a blend pot in place of the switch, but this might be a later project.
Currently the Tone Pots push pull to split the coils, and I would like to convert this to run them in parallel. I never use the split function and figure this might get me some more useful tones.
I can't seem to find a GOOD diagram to do this conversion.
Also considering changing tone Caps to a lower value as the .033 uf is just taking off too much of the treble.
Any Recommendations for Caps on the neck and bridge pickup?
Also considering a blend pot in place of the switch, but this might be a later project.