About to pull the trigger on a PRS - need a wiring diagram

[James Henry]

** Wrong section, sorry about that **

Going to be either a 245SE Standard. A Tremonti / black with the birds and binding, a Bernie Black (although I don't like the knob placement), or a Friedman.

I'm going to put the following in it.
Bareknuckle Warpig
Schroeder Bridge and locking studs (assume I need metric)
Schaller Locking tuners

What I'm wondering is this.
On my Jackson, I have coil taps, meaning I can flip a switch and have single coils. I think that is called coil tap? Sorry, not much of an electric guy.
I see on some diagrams they have push / pull pots? I'm assuming this is the same thing except instead of an external switch, you use the pot.

Now I have a couple questions
1. What is the proper POT to get. Link would be appreciated. Would need volume push / pull and tone.
2. I need a diagram. I found a good one, but it says north, south for the wires. I need one that lists the colors.

I do solder, I have a $200 soldering station. Copper shielding. Vintage cloth wire. I just redid a buddy's Jackson with new pickups. The issue I had was I ordered the wrong length shaft for the pots. Being I know nothing about PRS guitars, I'm looking for some guidance if someone on here would be so kind.

Thanks

 

[Mikegarveyblues]

Metric studs.
Coil splits on humbuckers. You shut down one coil with the switch. Coil tap is a little different.
Push pull audio taper pots.
Bare knuckle sell the pots. That's where I got mine. You'll need to ream the holes to accept the new pots.
Bare knuckle should have the wiring diagrams. I have a diagram for the Bernie that may be of help if you went that route, though it's not for coil splitting.
Short shaft.

 

[James Henry]

Metric studs.
Coil splits on humbuckers. You shut down one coil with the switch. Coil tap is a little different.
Push pull audio taper pots.
Bare knuckle sell the pots. That's where I got mine. You'll need to ream the holes to accept the new pots.
Bare knuckle should have the wiring diagrams. I have a diagram for the Bernie that may be of help if you went that route, though it's not for coil splitting.
Short shaft.

Thanks, anybody else on the wiring diagram, everything I see is coil tap or the push / pull on the tone instead of the volume. I thought this was going to be simple to find.

I think this is what I need, but I don't understand the series / parallel thing.

I've also read that the SE's require short leg pickups.
I'm wondering if 50mm is ok? Don't want to have to break out the dremel