58/15 LT wiring into Custom 24

[mnawe]

Hi!

I just bought some PRS 85/15 LT pickups to install in my Custom 24. These pickups are the ones that the PRS 594s mount, but the PRS website wiring diagram is for 2 volumes and 2 tones

Could someone help me to install these pickups, but only in 1 volume and 1 tone? I want the same option to switch from doubles to singles with tone push pull?

Thank you.

This is the 594 wiring diagram: https://d159anurvk4929.cloudfront.net/documents/594_2017.pdf

 

[Bowtiefanatc]

Look up the McCarty MC58 wiring. Similar to the DGT.

Did you happen to buy them off of FB?

 

[mnawe]

Thanks. I have looked for the scheme of that guitar and I have not found it.

the problem is that the 58/15LT only have one black and one white wire.

 

[Bowtiefanatc]

So wire the main lead to the switch, white to the low lug on the push pull. Put the resistors which are in the DGT diagram to the middle lug and ground the other side of the resistor to the pot. make sure to ground the shielding.

 

[garrettb]

Assuming your Custom does NOT have the blade switch, what you want is just McCarty wiring.

 

[Bowtiefanatc]

Assuming your Custom does NOT have the blade switch, what you want is just McCarty wiring.

Thats a very good point I didn’t think about

 

[mnawe]

Thanks!. The McCarty wiring was the solution.