Hi all,
Recently got the 24-08 from Sweetwater mailed to me. I’ve got a Gibson LP, Fender Strat, and an acoustic. I run all my guitars through a Polytune 3 (for the buffer) through a Line 6 Pod Go wireless. I use both in-ears at home and FRFR monitors. Never had any issues with this rig before...
I'm having trouble with the ground wire from the stop tail bridge breaking off from the solder joint as I reposition the pickguard to close up the guitar. I am new at this and am trying to learn. I am replacing the volume pots with core ones and thought the soldering went well. I am soldering...
Hi guys,
I just replaced the 58/15's in my 2019 McCarty (single conductor wiring) with 59/09's (four conductor), using this schematic: http://www.prsguitars.com/documents/custom3waytoggle.pdf
I installed the pickups exactly like the schematic:
Bridge pickup
- black wire (hot): to 3way toggle...
Help! pick guard swap goes wrong - lose wire?
So I was swapping the pickguard on my new PRS Mira SE (tortoise to black) and I was afraid of breaking anything...
Anyways my fears were realized when I noticed a loose black wire after swapping the tone pots and switches over. (I must have...
So I ordered the McCarty Drop In wiring kit for multi conductor to use with new 57/08 pickups (this was the instruction from PRS). The pickups have four wires each (black, white, red, braided ground).
While the product code on the kit matches, comparing the 3-way toggle diagram and picture on...
Sorry if this was posted somewhere but I am in need of a diagram to wire back to stock a PRS SE custom 24 with a 3-way blade switch and push-pull coil-split setup. I have a Mark Holcomb model with that setup but when I copied the wiring the pull switch operated backward and it sounded brutal, I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.