Mine had a slight hump between the nut and 5th or 6th fret that required a skillful truss rod adjustment. This hump and a nut that was a fair bit lower than spec were the problems I had fixed. If you haven't measured string height at the first fret, worth a look.
Thanks for responding. The nut slots are definitely too low. The A to high E strings are touching the first fret when I depress the third. Same for the method you suggested above. Only the G has a very light buzz when open, with relief at about .008" so I never thought to check string height at...
I recently discovered that my nut is well below spec causing some buzz when I pluck harder on some of the open strings. I have some ideas why but won't go into that here. I'm wondering if an owner or two would do me a favour and measure your gap at the first fret, low and high E, and let me know...
Someone suggested just loosening the screws and then tightening again, working diagonally. i've had to keep tweaking. My relief now is about .012 and acton on the low E at the 12th, just over 5/64.
Wow! Same thing for me, though I didn't see misalignment. I took off the neck to see if there were any issues and when I put it back on, the low E and A buzz was mostly gone.
I recently bought an SS that was shipped across the country to my door. For the first week or so I was very frustrated not being able to get rid of fret buzz on my low E and A, especially near the nut. Had it set up and still the buzz. Not knowing what to do next I took the neck off to see if...
Yes, the buzzing was audible on the low E and A even with fairly high action and relief. What's interesting is that pretty much all of this audible buzz disappeared after taking the neck off and putting it on again. Perhaps the screws were too loose or too tight on the neckplate? I'm thinking...
Interesting to note that after putting the neck back on, a touch less fret buzz where I had a problem, on the low E and A, lower frets. Perhaps the screws were on a bit tight.....
Thanks for these responses. I took the neck off to see if a shim had been added and thought neck angle might be an issue. I've read that PRS has sent out new SSs with shims. I'll look into adjusting the tremolo. I couldn't get the pics to take. They were of the heel so not needed now given the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.