Recent content by palfino878787

I’ve done the same and still not 100%. Is almost like the guitar is asking for .10s i stead of .09s

How did you solve it?

Thanks Boseph, I got in contact with PRS tech support and they confirmed the steps I mentioned before were correct.

Connecting the dots here. https://theelectricluthier.com/how-to-determine-guitar-bridge-placement-on-any-guitar/

Thanks

Apologies, but other manufacturers have all necessary instructions published. What’s wrong to learn? Isn’t that the purpose of the forum? This is a mechanical problem, nothing overly complex. Not my fault only 80% of the solution is published.

Still the answer is not clear: 1) Loosen all strings 2) Reset all saddles to the middle position in the bridge 3) using the allen key position bridge with top E 24.5 inchens from nut and bottom E slightly farther from bridge pick (as in photo show above) 4) tune high e and adjust saddle (not...

Thanks a log for this. Still there’s a missing data point. Before tuning to pitch, imagine if I was to install the bridge for the first time. Where should all saddles be? Before tuning for the first time. And what should be the starting distance of the bottom e? All these videos asume the only...

Thanks, and the bottom e? I’d like to “reset” the entire bridge. Should I place all saddles in the middle of the bridge? And then create the standard pattern? This is my bridge: https://share.icloud.com/photos/0703iV6S4SSRaCT49eSyVc_yA This is what I mean as standard pattern...

Thanks, I am aware of these. They come with the bridge. I’m trying to find the documentation how far back it should be.

I’m having intonation issues and the saddles of my birdge are bottomed out. Is there a way to reset this? i can’t fine any documentation about how to setup this bridge from scratch.

Thanks this is really helpful, did you need to modify the nut to use the .10s?

How much you got charged for the replacement of the nut?

Thanks, could you provide more info about your setup? I have a Zack Myer SE with 0.09-0.42 but have 20 mm action and still some buzz around 8th fret onwards on Lower E

Did you modify the nut to use 0.10s?