Erick_S's latest activity
-
EErick_S replied to the thread PTC praise.I have setups and full refinish done via the PTC and all work was spot-on. Pricey, but it came with the expectation of first-class...
-
EErick_S replied to the thread Low output after changing vol pot.Double-check the grounds in your circuit.. This happened to me once. I had flipped the hot and ground wires - the audio signal was very...
-
EErick_S replied to the thread new DGT... finish problem?.As of 2020, the entire Core production line transitioned to the nitro-over-cellulose (CAB) finish. The CAB is an acrylic formula. The...
-
EErick_S replied to the thread Custom color only with private stock orders?.Wood Library orders can get custom colors and sometimes even Private Stock colors, based on dealer spec requests. PRS is 2-3 years...
-
EErick_S replied to the thread Stoptail Bridges Interchangeable?.Yes.
-
EErick_S replied to the thread Refinish. V12 to Nitro (CAB?).As of last year, you had no option but to refinish in the nitro-over-cellulose (CAB) system. Their entire finishing line is nitro now...
-
EThe 594 is the best guitar ever made. GO FORTH. The Ted 245 is great. The 594 is even better.
-
EErick_S replied to the thread Gen II Tuners on a 89 CE24..The original Gen i and II tuners were made by Schaller. Gotoh later took over production of the Gen IIs and now makes the Gen IIIs as...
-
EErick_S replied to the thread Mistakenly bought low mass tuners.......They are really hard to align properly, since the pin prevents the tuner from sitting flat on the headstock. You would ideally have a...
-
EErick_S replied to the thread Toggle switch for a 2005 STANDARD 24.Yes. StewMac charges a fortune for shipping (probably $9 just for the switch), so if that one item is all you need, just hit eBay or...
-
EErick_S replied to the thread Toggle switch for a 2005 STANDARD 24.PRS uses Switchcraft toggles in their USA-built guitars (not sure about S2, though). Specifically, you will need the Switchcraft...
-
EErick_S replied to the thread Phase 3 tuner install on older PRS.They countersink in order to ensure metal-to-wood contact. Also, the tuner body has ring that prevents it from sitting flush unless the...
-
EErick_S replied to the thread Phase 3 tuner install on older PRS.You will need to countersink the pegholes - just slightly on the front, more so on the back. You will also need to drill new mounting...
-
EErick_S replied to the thread Trouble desoldering an SE.The wet sponge can trap contaminants, even if you use distilled water. The brass soldering tip cleaner is better at cleaning the iron...
-
EErick_S replied to the thread Full Braz neck vs Braz board w/Indian RW neck?.Inside vs outside : heartwood vs sapwood.
