Recent content by djd35de

I ran into the same problem with my Santana SE. I changed the saddles and six screws to mann made. -small difference. Pots to 550k volume 500k tone small difference. PRS USA Nut- better yet. Pickups to Manlius Hot rod neck in bridge position...

Callaham bridges are'nt stainless steel. they are made of high carbon steel which is the best conductor of vibrations.

Joern I think the only way to really get the full benefit is to change out the ( cheap zinc inserts). I've looked high and low but was'nt able to find a source. Iam about to also do a review on my Bernie Marsden with Callaham + other mods.

I'd get the 36th, thgey are stellar and won't squeal under high gain. Plus they have more clarity. David

Yea bone nut would be only thing i have not done. Think I'll just leave PRS nut for now.

Hmmm, not sure how to post photos.

Hello all, I got a Santana back in Chrismas time. It sounded ok stock, But I have to tinker and make it the best it can be. The neck pickup sounded pretty good for stock, but I really did'nt like the bridge too much. And I did'nt want to try...

I bought a Santana Se for Christmas too me lol. I've changed out the nut- USA-PRS better then stock plastic. But I still may opt for Bone later. Next I installed the 6 bridge screws and saddles from Mann made USA- helped a bit Then I...

Check the tilt of the bridge.

l

I got tired of waiting to see if this guy is going to report/review of the Callaham Prs bridge. So I bit the bullet and bought one. Won't be here till next week but I won't flake on you guys. I also think i found a source for the steel...

Should be .016 under low E-G then .014 under b-a strings. David

Well i may have found the solution. Faber has some epi tailpiece Steel metric inserts. Got them from Vision guitar so when I get them I'll let you guys know if they fit. I also ordered the Callaham Stopbar Bridge. There is a thread...

bump

Hey whats up with the callaham prs bridge? We are waiting.