Recent content by David Gibson

All great advice. Tried the suggestion of dabbing the PCB/coil connections while squeezing the two together. No luck. Bummed over the idea of sending off to PTC for an indefinite period of time for repair.

So I pulled the bridge pickup tonight. Have continuity from each wire off the coils to the soldered connection on the PCB on the back of the pickup. I also have continuity from the soldered connections on the pickup PCB all the way back to the 3-way switch. I sprayed electrical contact...

So I checked for continuity from the 3-way switch to each connection on the PCB and have good continuity on each. Then checked from each connection on the 3-way to the mini sockets where the pickups plug into the PCB. Have good continuity at each also. So all connections on the PCB would seem...

The bridge pickup on my 513 drops out in both the single coil and heavy humbucking modes only when just the bridge pickup is selected. The clear hum bucking position works just fine. Any suggestions on what the problem might be? Thanks for the help.