Thanks for the advises, I am aware that I have melted the finish but what I am asking is can a spreading nitro chip be stopped without melting an relatively large area of color nitro finish because nail polish will also leave a dark ring around it when there is no clear coat over the color(if it...
Hi,
My nitro McCarty's chipping was spreading(primer layer exposed) and I wanted to stop it so I dropped tiny bit of thinned nitro(2 nitro to 8 thinner) on a small dental pick after I cleaned the area with naphtha.
It seems the pigments floated up as there's no clear coat on the body's burst...
I wanted a MEV a while ago but I went with a Santana instead, for some reason I felt it's complete different to my 30th CU24, don't know why but the Santana's sound is very special.
Sounds like you need to take it to a luthier to see what can be done to accommodate your needs but gibson's headstock angle and a and tuner arrangement is always bit troublesome on tuning stability.
I think Mira is quite close to SG if you don't mind buying used.
If nothing else worked, try install a Tusq nut and use strings one gauge heavier?
When my 2019 LP had tunning issues I found out the tuner holes were oversized and "chewed", I have to bring to my local luthier to plug and redrill it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.