So for better or worse, I've got my HBII Archtop apart.
I cannot get both circuit boards out - only the large one with the jacks mounted on it.
My questions is: where would I install the treble bleed pot?
Usually I believe it goes on the volume control but in this case the volume control is...
So Red and White to respective middle lugs of Switch #1? (as it is in my diagram)
Check (as it is in my diagram)
I'm not following this... so green or black to the bottom lugs of switch #2?
Aren't these connected to the pickups?
Will have to understand what's going on above..
Hello,
I'm hoping someone can double check my spaghetti..
I'm looking to modify my HB2 Piezo by going to 4-conductor Seymour Duncan pickups and replacing the volume and tone with push/pull DPDT switching pots.
My goals are to have a coil split switch (humbucker/single coil) and a coil select...
Tangentially, can the Archtop pickups be coil tapped? Figure I might as well look into installing a push-pull coil tap if I'm going through the pain of getting the electronics out.
I hate dealing with wiring on a hollowbody guitar (any of them) but I'm curious to see what the spec of the volume pot is and wonder if replacing it with a higher value would solve the problem - although, from what it sounds like, this is a common issue with this guitar and those pickups.
I was...
Thanks! That's helpful to know... I assumed that there was no treble bleed cap and was hoping to avoid altering the inherent tone too much. Did the 400k pot impact the treble rolloff in your experience?
Hi All,
This is my first post about my first PRS. I came into a 2005 PRS Hollowbody Spruce with the Archtop pickups and absolutely love the guitar except for one annoyance. The treble rolloff on the volume pot when the volume is turned down, even slightly, is waaaayyyy too much. Instantly...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.